Echo POWER EDGER PE-265 Manual do Utilizador descarregar pdf (Página 11)

Po w e r ed g e r

oP e r a t o r 's Ma n u a l

5. Tighten two (2) drive shaft clamp bolts (B) securely.

6. Route throttle linkage and ignition lead assembly along shaft and

clip as shown.

t h r o t t l e l I n k a g e a n d I g n I t I o n l e a d s

1. Close choke and remove air lter cover.

2. Place throttle linkage (C) through adjustment xture (D) and install

wire end into large carburetor throttle swivel hole (E). Check

throttle for freedom of movement and that wide open throttle / low

idle extremes are adjusted properly. The throttle linkage must be

adjusted by moving the adjustment xture (D). Consult with your

Echo Dealer for correct adjustment procedure.

3. Connect 2 ignition stop leads (F, G) from throttle cable tubing to 2

ignition leads (F, G) on engine.

4. Secure ignition leads against engine housing with clip (H).

5. Install air lter and cover.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Sem comentários

Echo POWER EDGER PE-265 Manual do Utilizador Página 11