Echo PE-280 Manual do Utilizador descarregar pdf (Página 21)

Po w e r ed g e r

oP e r a t o r 's Ma n u a l

Level 2.

Tools required: Screwdriver, Tachometer (ECHO P/N 99051130017)

Parts required: None

NOTE

Every unit is run at the factory and the carburetor is set in compli-

ance with emission regulations. Carburetor adjustments, other

than idle speed, must be performed by an authorized ECHO

dealer.

1. Check idle speed and reset if necessary. If a tachometer is avail-

able, idle speed screw (A) should be set to the specications found

on page 25 "Specications" of this manual. Turn idle screw (A)

clockwise to increase idle speed; counter clockwise to decrease

idle speed.

WARNING

When carburetor adjustment is completed, the cutting attachment

should not turn at idle, otherwise serious personal injury may

result.

d r I v e s h a f t l u b r I c a t I o n

Level 1.

Tools required: 8 mm Open End Wrench, 4 mm Hex Wrench,

Clean rag

Parts Required: POWER BLENDX

8 oz. (P/N 91014) or Lithium

Base Grease.

1. Loosen two (2) screws (A) and remove center locating screw (B).

Pull gear box and shield from drive shaft housing.

2. Pull exible cable from the drive shaft housing, wipe clean and

recoat with a thin coating [15 ml (1/2 oz.)] of grease.

3. Slide the exible cable back in the drive housing. DO NOT get

dirt on the ex cable.

4. Install the gear housing and shield assembly.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Sem comentários

Echo PE-280 Manual do Utilizador Página 21