Echo CS-500P Manual do Utilizador descarregar pdf (Página 12)

CS-500P

WARNING

Saw chain is sharp! Always wear gloves

when handling assembly, otherwise serious

personal injury may result.

GUIDE BAR AND SAW CHAIN

INSTALLATION/REMOVAL

1. Remove spark plug lead. (See page 25)

2. Remove two clutch cover nuts and remove

clutch cover.

3. Remove bar and saw chain if necessary. See

“Maintenance and Care” section for guide bar/

saw chain maintenance procedures.

4. Unlock the chain brake, and mount guide bar on

studs and slide toward clutch to make saw chain

installation easier. Install chain with cutters on

top of guide bar facing forward.

Ensure chain tension adjuster pin ﬁts into the

guide bar adjuster hole.

5. Install the clutch cover over the guide bar studs.

Tighten clutch cover nuts ﬁnger tight.

Guide bar adjuster hole

Clutch cover

Nuts

Clutch Guide bar studs

PREPARATION FOR USE

Clutch cover

Brake lever

(Front hand guard)

Two nuts

Unlock chain brake

Spiked bumpers

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Sem comentários

Echo CS-500P Manual do Utilizador Página 12